AUTOMATIC WATER LEVEL CONTROLLER FOR STARTER PANEL TYPE PUMP

1. THIS CONTROLLER IS DESIGNED FOR STARTER PANEL TYPE PUMP, WHERE TWO START PUSH CONTACT AND SINGLE STOP CONNECTION IS REQUIERED
2. IT HAS TWO 30AMP RELAY FOR START PUSH BUTTON (PARALLEL CONNECTION) AND ONE 10AMP STOP
   RELAY (SERIES WITH STOP PUSH BUTTON)
3. AT LOW LEVEL FIRST STOP RELAY-3 WILL START TO MAKE NC CONNECTION AND THAN RELAY-1 & 2 WILL
   START TO PUSH THE START BUTTON.
4. AT HIGH LEVEL STOP RELAY WILL DEACTIVE AND STOP THE PUMP
5. DIP SWITCH IS GIVEN TO SET FLOW DETECTION TIME DELAY (60, 90, 120 AND 150 SEC.), IF FLOW NOT DETECT
   WITHIN THIS TIME PERIODS, IT WILL STOP THE PUMP AND FLOW LED WILL BLINK, AFTER 60 SEC. IT WILL AUTOMATICALLY RESET AND START THE PUMP IF AGAIN FLOW NOT DETECT IT WILL STOP THE PUMP, THIS CYCLE CONTINUE FOR 3 TIMES. AFTER THAT USER HAVE TO MANUALLY RESET THE CONTROLLER
6. IF LOW LEVEL SENSOR IS OPEN AND HIGH LEVEL DETECT, IT WILL GIVE LEVEL SENSOR FAULT ALARM AND
   LOW LEVEL LED WILL BLINK.
7. MANUAL START FUNCTION BY SHORTING MANUAL PIN RELAY-3 WILL ON AND OPERATOR CAN START/STOP THE PUMP FROM STARTER PANEL'S PUSH BUTTON.
8. IN ANY FAULT CONDITION RESTART POWER SUPPLY OR PRESS RESET PIN.

#WaterLevelController